CCC certified
Three starting modes: constant current, voltage ramp, pulse kick-start
LED operating panel
KULUN / Soft Starter
MS21-M Soft Starter (Standard)
KULUN MS21-M: standard bypass-type low-voltage AC motor soft starter with microprocessor control, 5.5-630 kW for pumps, fans and crushers.
Mains Voltage RangeAC 110–440 V (mains)
Matched Motor Power5.5–630 kW
产品特征
技术参数
Input | Mains supply | AC 110–440 V, 45–65 Hz |
Control supply | AC 220 V, 50/60 Hz | |
Output | Output type | Bypass type; external bypass contactor required |
Rated range | 5.5–630 kW | |
Operating characteristics | Starting modes | Constant current, voltage ramp, pulse kick-start |
Duty | Short-time duty, max. 10 starts per hour | |
Key features | Stopping modes | Soft stop, coast stop |
Start / stop time | 1–120 s | |
On-line monitoring | Not supported | |
Inputs | 4 digital inputs (run, stop, jog, programmable) | |
Outputs | 2 relay outputs (fault, bypass), NO contact, AC 240 V/3 A, DC 24 V/5 A | |
Communication | Modbus RTU | |
Current transformers | 3 built in | |
Protection rating | IP20 | |
Protection | Mains fault | Protection on mains frequency out of range, undervoltage or input phase loss |
Phase imbalance | Protection when load current exceeds the imbalance threshold | |
Overheating | Protection when thyristor temperature > 85 °C | |
Overcurrent | Protection when output current reaches the set multiple | |
Motor phase loss | Protection when load current falls below the threshold setting |
典型应用
The MS21-M is a standard bypass-type low-voltage AC motor soft starter with on-line monitoring. Its 3-in 3-out structure and microprocessor control integrate starting, display, protection and data acquisition. Multiple starting modes start heavy loads with ease, for motors from 5.5 kW to 630 kW. Widely used on three-phase AC motor drives such as compressors, pumps, fans and crushers.
FAQ
How to confirm output voltage and current range?
AC 110–440 V (mains); 5.5–630 kW (matched motor power).
Which applications does it suit?
Three-phase AC motor drives — compressors, pumps, fans, crushers — with constant current, voltage ramp or pulse kick-start modes for heavy loads.
What information is needed for selection?
Site voltage, current, load type, control mode, installation conditions and process requirements.
选型咨询
请提供应用行业、设备工况、电压电流、功率范围和现场环境，工程师将协助确认方案。
